The Imperfect Loaf

Baking bread, one imperfect loaf at a time.

Today’s Loaf: A 100% Wholemeal Loaf

  • 750g Matthews Heritage Broadway wholemeal bread flour
  • 600g water (80%)
  • 8g dried yeast
  • 16g salt
  • 50g honey

In my experience making bread, 100% wholemeal loaves are often dense and stodgy. I wanted to try using this heritage flour, presumably from the area around Broadway, a town about midway between where I live and where the miller is located. It’s a very strong flour, with 13.6% protein (The website currently shows it as 11% protein, but my bag says 13.6%.)

I autolysed the flour for 45 minutes, then added the yeast and salt and mixed it in my Ankarsrum for about 12 minutes using the roller. The Miller’s website gives a recipe for a whole meal loaf at 63% hydration. Since I use more water than that when I make a 50–50 loaf, I figured I would try 80%. Recipes that I have found in books and online talk about higher hydration for wholemeal flour, some as high as 90%. 

When mixing, it was clear that this dough was going to be very slack, but I didn’t want to add more flour. It was slightly slacker than some other high-hydration doughs that I’ve made; I was actually surprised, because the flour is so dense I thought it would’ve absorbed the water much more. Nevertheless, it wasn’t sticky and was relatively easy to handle once I took it out of the bowl. I gave it a few folds and put it in a box for bulk fermentation. My kitchen was cold, just under 21°, and I checked after 30 minutes, but it didn’t seem to have risen enough, so I left it another 10 minutes. 

I took the dough out, gave it a few folds, then put it in my pan to rise. I usually let dough rise in the pan for 30 minutes, but I left it for 40 minutes because of the kitchen temperature and the density of the dough. I baked the loaf for 25 minutes with the top of the bread cloche on, and 20 minutes off. 

This loaf was surprisingly good. It was only slightly denser than my usual loaves, and it was quite soft, with a very nice crumb. Two small problems. There were some blisters on the top crust, and the crust overall was darker than usual. Both of these were probably caused by the honey in this recipe, but that little bit of sweetness gave it a very nice flavor and compensated for the bitterness of wholemeal flour. Perhaps next time I will leave the top of the bread cloche on a bit longer, yet still bake for the same amount of time. I will also reduce the hydration a bit; 80% was fine, but I could probably drop this to about 76%. 

Note that in the photo of this loaf above, the crumb looks a little bit sticky in the middle. I usually let my bread cool more before I slice it, but I wanted to eat this for lunch. I probably sliced it too early.

Leave a Reply

Your email address will not be published. Required fields are marked *